mrsmith
Well-known member
What quite a bit of fun.
https://youtu.be/PogJaJgyONk
https://youtu.be/PogJaJgyONk
SSi3 said:how did you disable? pull fuses?
SSi3 said:now you just need some snow
how did you disable? pull fuses?
mrsmith said:I woudn't recommend you do this on the road, you may also permanently damage your car. Do NOT do what I describe below!
>Turn ignition on
>Hold down the trip reset button on the side of the speed readout display (I didn't know it was there until someone told me about this technique).
>A menu will pop up at the the bottom of the speedo screen
>Short press of the trip reset button will move you through the options
>One will be 'Dyno test' or something like that
>Long hold on 'Dyno' option until the next screen pops up asking you to confirm
>Short press of the button and you will get lots of warnings!
>ABS is disabled, traction disabled, engine regeneration is disabled
>Spin those wheels!
To reset just turn off car and lock, when you unlock all will be back to normal. I assume this mode is available to allow running of the car on a DYNO to test BHP etc. Running a modern car on a DYNo where just one set of wheels spins, with ABS/Traction systems can send those computers nuts and throw up all kinds of errors.
DeJay58 said:That's very unsafe and stupid!
Why don't you just switch to "N" the last 5km when you brake?! Same effect but safe because you then still have the break booster (powerbrake) (don't know the correct word).
Enter your email address to join: