Recent content by zlykot

This is with the car being driven at low speed/load, noise only happens when the car is rolling and is speed dependent. Happens in Drive, Reverse or Neutral. I initially suspected rotor/pad/bearing issue but the noise is not coming from that location. I also fired up the Rex in emissions test...

Here is how this sounds, the drive unit is coming out soon. https://www.youtube.com/watch?v=8Sxw6tx7qU0

I did ISTA diagnostics, the following things were of note(below). I ran the test plan for the Inverter and EME internal fault but nothing really came up although I got some decent reading material from it. The position sensor is internal to the assembly and not on the output shaft side, meaning...

Hey all, Troubleshooting my GFs I3, MY15 with 54k on the clock. Over the last 5k miles the drive unit has been progressively getting louder. No unusual noises aside from the typical electric sound until last week where the car ended up "not going into gear" with a drivetrain malfunction message...

Hi all, Has anyone captured the can bus message that is produced by the hod control unit (32-30-6-875-202). Looking for a fun diy project... Thanks Tom