Battery discharging while Stationary

BMW i3 Forum

Help Support BMW i3 Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

MarkH

Well-known member
Joined
Jun 10, 2019
Messages
94
My i3 had been unused while we were away for 2 months. I had connected the 12V battery to a solar panel, through a controller, to keep it charged.
When we got home, the car was dead. A cigarette lighter voltmeter showed a reading of < 10V. (This time last year, all was fine with this regime.)
I got the AA (car club roadside service) guy around and he connected a Jump-start 12V battery in parallel.
The car lit up immediately and I could do all the normal things.
HOWEVER, now, when I turn it on in the mornings, I get a message advising that the "Battery is discharging while stationary" and the %charge has dropped about 4% overnight.

It is a 2016 BEV.

Is my 12V battery had it? or is there a test I can do using a VPeake ODB device?
 
MarkH said:
Is my 12V battery had it? or is there a test I can do using a VPeake ODB device?
That message is displayed when the 12 V battery's voltage is low. Jump-starting from another battery didn't charge your battery, so its voltage is still low. That happened to our battery. I attached a 12 V battery charger overnight and haven't seen this message again.

Your battery might be failing, but it might also only need a full charge. I would try charging it before replacing it because it might not be bad.
 
MarkH said:
Do I need to disconnect the negative while charging? or not?
Depends on the charger's amperage. My multistage charger charges at only 0.8 A. After an overnight charge, my charger hadn't progressed to the final stage due to the car's vampire load. After I disconnected the negative cable, charging completed within a couple of hours. I had disconnected the high-voltage disconnect prior to charging.
 
OK. Mine is on charge now. I'll see how it behaves in the morning.
My i3 number is 16-07-503 so it seems that I don't have to do the dis-connecting thing from the HV.

Just a question.
With an ICE car, the battery is recharged (after starting) from an alternator that spins while the engine is running:

How does the i3's battery get recharged when it becomes significantly discharged?
If the answer is "From the HV whenever the car is unlocked" why does it not do a full recharge using this method?
Is there no way that the car, by itself, can recover from a discharged vehicle battery?
 
The whole point of the 12v battery is to power all the systems that support the traction battery control so if the 12v is flat there is no way the car can get power from the traction battery. If it was recoverable by itself there would be no point in having the 12v battery.
 
Sure: - if it's dead flat.
But I understand that it maintains its full charge by being topped up from the HV and this happens when any of the doors or front or back hatches are opened.
My question is, given that it can top up small amounts of normal discharge by using the HV, why can it not do a more complete recharge if the 12V becomes significantly (but not completely) discharged?
 
If the 12v battery is worn out then it might not hold charge long enough between switchons. It probably could be arranged to continuously top up but then a fading 12v might continuously pull charge and lose it running the risk of fully flattening the traction battery which is very damaging and costly to BMWs battery warranty. Several manufacturer's BEVs seem to eat 12v batteries so its quite possibly a design choice rather than a fault.
 
MarkH said:
But I understand that it maintains its full charge by being topped up from the HV and this happens when any of the doors or front or back hatches are opened.

Nope. Just like an ICE car, it is just draining the 12v when you open the door and the interior lights come on. If you close the door(s) or leave them open and walk away, it times out at just under 13 minutes and shuts off the 12v power. That includes power to the 12v outlets as well. If you do anything else during that time like open another door, the timer resets. The HV battery is not "on" during this time. While the 12v cycle is "on" a fully charged 12v battery which would normally read ~12.9v when resting will show ~12.5v when it is being used by the interior lighting and whatnot. Once that cycle times out, the voltage reading goes back up to 12.9v

If you turn the vehicle "on" as in: Push the button on the stalk and put the car into "Ready" state, THEN the HV battery will kick in to re-charge the 12v. The reading at the terminals will then be just under 15vdc.
So that means it will also recharge the 12v battery while the car is sitting in Ready State or Driving.

My question is, given that it can top up small amounts of normal discharge by using the HV, why can it not do a more complete recharge if the 12V becomes significantly (but not completely) discharged?

If the 12v battery is "significantly" discharged to begin with, this is not normal.
The HV battery CAN do a more complete recharge but the 12v battery must be able to accept it.

As mentioned already it can't keep up with a worn out or shorted out 12v battery.
Some people mention smelling "rotten eggs" and find their 12v to be really hot. The battery is not holding a charge and all the energy that is trying to recharge the battery is being converted to heat instead.

The battery might also charge to 12.9vdc but if left to sit, it may self-discharge over a short period of time but the HV will apparently come on once it reaches a certain threshold and bring it back to 12.9vdc without any other intervention.
This would explain why some people have reported that their HV battery has "mysteriously" discharged by a few percentage points overnight or over a few days time and then later the 12v failed completely.
 
MarkH said:
My question is, given that it can top up small amounts of normal discharge by using the HV, why can it not do a more complete recharge if the 12V becomes significantly (but not completely) discharged?
Good question! I have noticed that the high-voltage system remains on for at least 30 minutes after I unlock the doors of our 2014 i3. During that time, the 12 V battery is almost always being charged because the 12 V system voltage is ~14.3 V. Especially after having driven recently, I have seen the DC-DC converter turn off before the auxiliary power port's 12 V power turns off. In these situations, the 12 V system voltage drops from ~14.3 V to 12.x V which might indicate that the 12 V battery is fully-charged.

I have no evidence that the high-voltage system remains on until the 12 V battery is fully-charged. In fact, the voltage of our 12 V battery seems to be lower than normal, probably because we drive so little. If the high-voltage system kept the 12 V battery fully-charged, the voltage of our 12 V battery wouldn't be lower than normal. This has been true for years, so it's not due to our 12 V battery being weak.

I suspect that gt6k's explanation has merit.
 
alohart said:
I have noticed that the high-voltage system remains on for at least 30 minutes after I unlock the doors of our 2014 i3. During that time, the 12 V battery is almost always being charged because the 12 V system voltage is ~14.3 V. Especially after having driven recently, I have seen the DC-DC converter turn off before the auxiliary power port's 12 V power turns off. In these situations, the 12 V system voltage drops from ~14.3 V to 12.x V which might indicate that the 12 V battery is fully-charged.

That's interesting. Perhaps there is a difference between the 2014 and the 2017 then?
I've not been able to get any interior lights/power ports to stay on longer than 13 minutes on my car after ceasing activity.
I've also not ever noticed the voltage reading higher than 12.5v when the interior lights are active. It pops back up to 12.9 once the cycle times out.
These are readings from the battery terminals.
 
Thanks for the replies.

I had the 12V on charge overnight for 18 hours without isolating it.
When I opened up this morning I no longer got the message about "discharging while stationary".
I'll check tomorrow morning to see if there is a SOC drop in the HV overnight.
 
EvanstonI3 said:
That's interesting. Perhaps there is a difference between the 2014 and the 2017 then?
Our 2014 i3 has November, 2018, system software. I would think that differences in charging behavior would be implemented in software, although the DC-DC converters could differ, I suppose. The apparent differences between the 12 V battery charging behaviors are substantial.

EvanstonI3 said:
I've not been able to get any interior lights/power ports to stay on longer than 13 minutes on my car after ceasing activity.
The entertainment system in our i3 turns off several minutes after our i3 exits drive ready state. However, the auxiliary power port remains on for a longer period powering the voltmeter display showing that the 12 V battery is almost always being charged.

EvanstonI3 said:
I've also not ever noticed the voltage reading higher than 12.5v when the interior lights are active. It pops back up to 12.9 once the cycle times out.
These are readings from the battery terminals.
Voltage readings at the battery terminals agree with those at the auxiliary power port in my experience.

I'm guessing that the charging behavior differences are due to the voltage of our 12 V battery being lower than average due to our infrequent driving (less than 12k miles since November, 2014). As a result, the DC-DC converter almost always begins charging our significantly discharged 12 V battery whenever the high-voltage system turns on. I have seen 12 V battery charging cease before the auxiliary power port turns off, but that's not common.

When I unlock the doors, the auxiliary power port turns on before the DC-DC converter begins charging the 12 V battery. The 12 V system voltage drops as low as 11.8 V before the DC-DC converter begins charging the 12 V battery (within ~5 seconds of unlocking the doors). I have short videos of a voltmeter connected to the battery terminals and a voltmeter in the auxiliary power port below the center of the dashboard, both showing the voltage drop rather rapidly when the doors are unlocked. When I first noticed this behavior, I was concerned that the 12 V battery was failing and made one of the videos to show the shop manager of the local BMW dealer. He told me that this behavior was normal for i3's and that my 12 V battery tested normal.
 
Took too long getting a replacement. :eek:
Battery now completely dead - cannot drive.
What are the specifications for a replacement 12V battery, please?
Will have to fit it myself.
 
MarkH said:
What are the specifications for a replacement 12V battery, please?
20 Ah AGM battery with a vent valve on each cell with a common outlet tube that can be connected to the i3's vent tube (i.e., not a power sports battery)
8.13" (207 mm) L x 3.56" (90 mm) W x 6.38" (162 mm) H
The battery should be an auxiliary rather than a starter battery.
The terminals need to be automotive terminals or a screw terminals to which the screw-on automotive terminals on the OEM battery can be attached.
The positive terminal should be in the front right corner.

In U.S. i3's, the OEM battery is a relabeled East Penn Manufacturing AUX18L. This can be ordered from a local East Penn Manufacturing retailer or from an online store. This battery is sold under several brand names including Deka and Remy.
 
Thanks Art.
Will see what I can find here in NZ.
Frunk is in the dark end of the garage: any way of turning the car around (pushing) that you can think of?
 
FWIW, you can't maintain a battery trickle charge in most any BMW vehicle when using a 12v socket (i.e., cigarette socket), as those get disconnected when the vehicle goes to sleep. You need to connect the trickle charger directly to the battery or the provided terminals, on those that have them, and except for some of the earlier software configurations, it's safe to do that, but earlier software needed to have the HV safety disconnect pulled to then safely recharge the 12vdc battery.
 
You need to connect the trickle charger directly to the battery or the provided terminals
Yeah. I did that. Don't think that was the cause of the battery failure. Just that it's 5 years old :?
 
MarkH said:
Frunk is in the dark end of the garage: any way of turning the car around (pushing) that you can think of?
Probably easier to do what's necessary to get better lighting into the frunk. Without 12 V power, I doubt that it's possible to shift out of Park or to release the parking brake.
 
Back
Top